Specifications

Installation and Programming DPH Series VHF Radio
Page 2-4 BK RADIO
2.2.2.1 Group Password
1. After entering programming mode the display will show PRG Ch 00.
2. Press the [FCN] key.
3. The display will indicate the password for the selected group.
4a. If no change is needed for the group password, press the [FCN] key to
advance to the next section.
4b. A new password can be entered by pressing number keys. Press the
[ENT] key to store the new password and advance to the next section.
2.2.2.2 Automatic Numeric Identification (ANI)
1. After the group password is set, the display will indicate the ANI ID
number (as many as seven digits may be used). The ID number can be
used for either radio management or transmitted as a DTMF tone burst
for ANI purposes. The ANI can be enabled or disabled. See “ANI/DTMF
Mode” in section 2.2.2.8.3.
2a. If no change is needed for the ID number, press the [FCN] key to
advance to the next section.
2b. A new number can be entered by pressing the [CLR] key, followed by
number keys. The digits will appear at the right of display and move to
the left. Press the [ENT] key to store the new ID number and advance to
the next section.
2c. The existing ID number can be incremented one digit by pressing the
[PRI] key.
2d. Press the [ENT] key to store the new ID number and advance to the next
section.
2.2.2.3 Transmitter Time Out Timer
After the ID number is set, the display annunciator will indicate PRG TX.
This is the duration of the transmitter Time Out Timer. 0 SEC means the
Time Out Timer is disabled.
1. Press the [PRI] key to increase the Time Out Timer duration by 15
seconds, with a maximum of 225 seconds (3 minutes, 45 seconds).
Press the [PRI] key again to change the duration from 225 seconds to
zero.
2. Press the [CLR] key to set the Time Out Timer duration to zero.
3. Press the [ENT] key to store the changed setting and advance to the
next section.
4. Press the [FCN] key to advance to the next section if no change is
needed.
123
456
789
0
*
#
CLR
FCN
PRI
ENT
PRG