Specifications

6 BK Radio
When an option is enabled, the
corresponding number in the display will
flash. When the option is disabled the
number is steady. If you wish to change the
option from enabled to disabled or vice
versa, press the number key corresponding
to that option.
Options 1 Through 7
Reserved for future options.
Option 8: Group Scan List
When Option 8 is enabled (flashing) the
current group will be scanned when the
radio is operating in Group Scan Mode.
Press the [ENT] key to store the group
options settings into memory and advance
to the next field.
Press the [FCN] key to advance to the next
field without saving changes.
2. Group Label
This field shows the label for the Channel
Group. Each Channel Group can have a
label of up to twelve characters or spaces.
The characters can include 0-9, A-Z, –, -, .,
*, +, <, >, /, \, |, $, %, h, or blank.
If no change is needed, press the [FCN] key
to go back to the starting point for Channel 0
settings.
NOTE: Special software available from BK
Radio lets you enter Group Labels and
Channel Labels from a computer. Contact
your dealer for information.
PRG
LABEL 1
GROUP LABEL
PRG
1-12345678
88
8
GRP OPTIONS
Keypad Programming Manual 23
NOTE: BK Radio current drain and battery
life specifications are based on performance
with the battery saver on.
Press [PRI] to toggle the option on or off.
Press [ENT] to store the setting and
advance to the next field.
19. Review Global Parameters (GRP 00)
Press the [FCN] key repeatedly to display
each setting in GRP 00, and then return to
the GRP 00 starting point.
E. EXIT PROGRAMMING MODE
1. Rotate the OFF-VOL knob counterclockwise
to the OFF position.
2. The radio will be in normal Operating Mode
the next time it is turned on.
CLONING RADIO SETTINGS
Any “Master” radio (a DPH-CMD with the desired radio frequencies
and settings) is capable of transferring its program to another DPH-
CMD radio. The radio receiving the program is referred to as the
“Slave” or “Clone.” The LAA0700 cloning cable will be required in the
following procedure.
Data that can be cloned to another DPH-CMD
radio includes:
 Group data (GROUP 1 – 25)
 Command Group data (CMND GROUP)
 Global data (GROUP 00)
 User Pick Lists (PICK LISTS)
When the Master’s Command Group is cloned
to a slave, the channel data that is ‘pointed to’
by the Command Group is transferred to a
target group (not the Command Group) in the
slave. The target group’s label in the slave will
be set to “CMND CLN”.
CMND CLN