Specifications

24 BK Radio
Master
Clone
Master
Switch
PSWRD -******
NOTE: Some groups may be “locked” by PC
programming to prevent them from being
overwritten. Only “unlocked” groups will accept
incoming clones.
1. Make sure the battery packs for both radios
are charged.
2. Attach the master switch end of the cloning
cable to the side connector of the Master
radio.
NOTE: One plug of the cloning cable has a
push-button master switch. This plug must
be attached to the Master radio.
3. Turn on the Master radio.
4. Put the Master radio in Programming Mode
by pressing and holding the master switch
then pressing and holding the [FCN] key
until the display shows ‘PSWRD-******’.
Enter the 6-digit password. The display
shows ‘PRG CH 00.’
5. Connect the other plug of the cable to the
side connector of the radio you want to
clone.
6. Turn on the clone and set it to the desired
target channel group.
7. Press the [*] key on the Master radio
keypad. The radio will respond showing the
prompt ‘PROG|DPHCMD’ on the first line
and ‘Group XX’ on the second line, where
XX is the currently selected group. (When
cloning Global parameters, this will be
‘Group 00’).
8. Long [#] keypresses will cause the second
line of the display to cycle through the data
blocks that can be transferred to the target.
Target Valid Data
DPHCMD
GROUP 00 or GROUP 01 - 25
CMND GRP
PICK LISTS
PRG
ch 00
PROG|D
PROG|DPROG|D
PROG|DPHcmD
PHcmDPHcmD
PHcmD
Group 01
Press and Hold [#] Key
to Change Data
PROG|DPHcmD
Cmnd group
Cmnd groupCmnd group
Cmnd group
PROG|DPHcmD
pick list
pick listpick list
pick listS
SS
S
Keypad Programming Manual 5
3. Global Parameters (GRP 00) include:
 Keypad Programming Password
 ANI ID
 PRI-1 Channel
 PRI-1 Group:
(skipped if Channel = OFF or MAIN)
 PRI-2 Channel
 PRI-2 Group:
(skipped if Channel = OFF or MAIN)
 TX on PRI-1
 PRI-1 Lock
 Scan List Lock
 TX Time-Out Timer
 Scan Delay
 Busy Channel
 ANI/DTMF
 Backlight Triggers
 Backlight Duration
 Silent Mode
 Battery Saver
B.
GROUP PARAMETERS (CH 00)
Press the [FCN] key at the CH 00 prompt to access group
parameters.
1. Group Options: 1-12345678
This is a group of eight individual options
that can be enabled or disabled.