Specifications

4 BK Radio
1. Group Parameters (CH 00) include:
 Group Options:
1-12345678
(1-7 = undefined, 8 = group scan list bit)
 Group Label
To edit channel data, at the CH 00 prompt
enter the number of the channel to be
programmed, or press the [PRI] key to
increment to the desired channel. Press the
[FCN] key repeatedly to cycle through the
data fields, and then loop back to the CH
entry point.
2. Channel Parameters (CH 01 – CH 20)
include:
 Bandwidth
([#] key at CH prompt toggles Wide/Narrow)
 RX Frequency
 RX Mode
 RX Guard
 RX NAC
 Squelch Mode
 TX Frequency
 TX Mode
 TX Guard
 TX NAC
 Talk Group ID
 Channel Label
To edit global data (GRP 00), press and
hold the [#] key at any CH prompt to get the
group selection prompt. Enter ‘0’ to select
global data. Press [FCN] to access the
data. Press the [FCN] key repeatedly to
cycle through the data fields, and then loop
back to the GRP 00 entry point.
Keypad Programming Manual 25
CLONING
CLONINGCLONING
CLONING
Group 01
9. Once the data to be transferred have been
selected, press the [FCN] key on the Master
radio keypad. The top line of the display will
flash ‘CLONING’ while the program in the
master is being downloaded to the clone.
10. If the download was successful, the display
on the Master will again display the clone
prompt (target and data to be transferred).
• To clone another channel group, press the
Master radio’s [CLR] key. Navigate to a
‘CH’ prompt, then press and hold the [#]
key to get the ‘GRP’ prompt.
• To clone Global Parameters, select Group
00 at the ‘GRP’ prompt.
• If cloning is finished, turn off the Clone
and disconnect the cloning cable. Normal
radio operation will occur when you turn
on the Clone.
11. If the download was not successful, the
master will flash ‘FAILURE’ and multiple
beeps will follow. Failure of downloading can
be due to:
• Improper connection
• Failure to turn on the clone
• Setting the clone in Programming Mode
• Target radio’s group ‘locked’ by PC
Programming
NOTE: To stop the ‘FAILURE’ Mode, press
[CLR], turn off both radios, and try
again, starting with Step 1.
1 2 3
4 5
6
7 8
9
0
*
#
CLR
FCN
PRI
ENT
FAILURE
FAILUREFAILURE
FAILURE
Group 0
1