Specifications

14 BK Radio
12. Channel Label
This field is the channel label for channel 1.
If this label is correct press the [FCN] key to
proceed to the entry point.
If a new channel label is desired, follow the
instructions under "Group Label" on page 6
of this manual.
After the CHAN LABEL is set, the display
will return to the Channel 1 starting point. If
you wish to review the settings for Channel
1, subsequent pressing of the [FCN] key will
show each value and then return to the
Channel 1 starting point.
At the starting point for Channel 1, the
display will show ‘PRG CH 01’. Press the
number keys for another channel number to
gain access to the settings for that channel.
Each channel is then programmed using the
same steps described for Channel 1.
D. GLOBAL PARAMETERS (GRP 00)
At any ‘CH’ prompt, press and hold the [#] key to
get the ‘GRP’ prompt. Press ‘0’ on the keypad.
The display will show ‘GRP 00’. Press [FCN] to
access global parameters.
1. Keypad Programming Password
The current keypad programming
‘PASSWORD’ is displayed.
If no change is needed, press the [FCN] key
to advance to the next field.
A new password can be entered by pressing
number keys. Press the [ENT] key to store
the new password and advance to the next
field.
PRG TX
Label 18
Chan label
PRG
Grp 00
PRG
Edit-000000
password
Keypad Programming Manual 15
2. Automatic Numeric Identification (ANI)
This field is the ‘ANI ID’ number (as many as
seven digits may be used). The ID number
can be used for either radio management or
transmitted as a DTMF tone burst for ANI
purposes. The ANI can be enabled or
disabled. See “ANI/DTMF Mode”.
If no change is needed for the ID number,
press the [FCN] key to advance to the next
field.
A new number can be entered by pressing
number keys. The digits will appear at the
right of display and move to the left. Press
the [ENT] key to store the new ID number
and advance to the next section.
The existing ID number can be incremented
one digit by pressing the [PRI] key.
Press the [ENT] key to store the new ID
number and advance to the next field.
3. Priority 1 Channel
This field is the ‘Priority 1 Channel’. Any
one of the 500 channels in the radios can be
designated as the Priority 1 channel, or PRI-
1 can be tied to the Channel Selector knob,
or programmed OFF. If the radio is
programmed to transmit on the first priority
channel, transmissions will occur on PRI-1, if
PRI-1 isn’t programmed OFF, when
operating in Single or Dual Priority Scan
Mode.
If PRI-1 is a fixed channel and the [PRI] key
on the keypad is not locked out during
normal radio operation, the user can select a
new group, if necessary, move the channel
selector to a new channel and press the
[PRI] key to choose a new PRI-1 channel.
PRG
ANI 1234567
Ani id num
PRG
CHANNEL 1
PRI-1 CHAN