Specifications

12 BK Radio
the three digit code has been entered allows
the digital code to be inverted. When the
displayed value is correct, press the [ENT]
key to store the Channel Guard and
automatically advance to the next field.
10. Transmit NAC
This field is the Network Access Code
(NAC) for Channel 1 transmit. This value is
only used if the transmit mode selected was
Digital or Mixed, or if User Channel Guard is
activated.
To see the NAC displayed in hexadecimal
format, press and hold the [#] key.
To return to the decimal display, press and
hold the [#] key again.
a. If the NAC is correct, press the [FCN]
key to advance to the next field.
b. If a new NAC is desired, press the
[CLR] key
In decimal mode, valid entries are 0 – 4095.
The values 3966 and 3967 are reserved for
receivers and cannot be entered.
In hexadecimal mode, valid entries are $0 -
$FFF. The values $F7E and $F7F are
reserved for receivers and cannot be
entered.
To enter hexadecimal characters A - F:
Each long press of the [2] key toggles the
rightmost character from A to B to C, then
back to A.
Each long press of the [3] key toggles the
rightmost character from D to E to F, then
back to D.
To enter a ‘letter’ after another ‘letter’ or
number, first enter any number, then toggle
it with long [2] or [3] key presses.
PRG TX
$293
Tx nac
Keypad Programming Manual 17
6. Priority 2 Group
If the Priority 2 channel has been
programmed as one of the 500 channels in
the radio, the group where the channel
resides must be designated. If PRI-2 has
been tied to the Channel Selector knob (set
to MAIN), or programmed OFF, the Priority
Group field is skipped.
Press the [PRI] key to cycle through the
priority group options, or press number keys
to enter a group.
Press the [ENT] key to store the new priority
group and advance to the next field.
7. Transmit On Priority 1
When TX ON PRI-1 is ON, transmissions will
occur on PRI-1 (if PRI-1 isn’t programmed
OFF) when operating in Single or Dual
Priority Scan Mode. To simulate BK Radio’s
Old-Style Priority Mode C, Transmit on
Priority 1 must be enabled.
Press [PRI] to toggle the option on or off.
Press [ENT] to store the setting and
advance to the next field.
8. Old-Style BK Priority Scan
The radio can be programmed to mimic the
Old-Style BK Priority Scan Modes as follows:
Mode PR1 TX on PR1 PR2
A Main No Off
B Fixed Channel # No Off
C Fixed Channel # Yes Off
PRG
on
tx on pri-1
PRG
GROUP 2
PRI-2 GROUP