Operating instructions

DMH Series VHF Radio Installation and Programming
BK RADIO Page 2-13
2.2.3.4 RECEIVE ANALOG CHANNEL GUARD
The next field is the Analog Channel Guard value for Channel 1 receive.
This value is only used if the receive mode selected was Analog or
Mixed, or if User Channel Guard is activated. The upper display will
show ‘PRG RX CG' and the lower part of the display will show the
programmed guard.
NOTE: 0.0 indicates carrier squelch operation (no Channel Guard).
1. If the displayed value is correct, press the [FCN] key to advance to
the next field.
2. If a new value is desired, press the [CLR] key to reset the display to
0.0. Press the number keys 0 thru 9 to enter a CTCSS Channel
Guard value. See "CTCSS Channel Guard Values" in section 2.4 of
this manual. Press the [ENT] key to store the new value and
automatically advance to the next field.
3. To enter a CDCSS Channel Guard value press the [#] key, causing
the letter ‘D’ to appear followed by three zeros. Enter the desired
code using keys 0 thru 7 (keys 8 & 9 do not respond). See "CDCSS
Channel Guard Values" in section 2.5 of this manual. Pressing the
[PRI] key after the three-digit code has been entered allows the code
to be inverted (a dash appears to the right of the number). When the
displayed value is correct, press the [ENT] key to store the Channel
Guard value and automatically advance to the next field.
2.2.3.5 RECEIVE NAC
The next field is the Network Access Code (NAC) for Channel 1 receive.
This value is only used if the receive mode selected was Digital or
Mixed, or if User Channel Guard is activated. The upper part of the
display will show ‘PRG RX ID CG’. The lower part of the display will
show ‘NACXXXX’ where XXXX is the Network Access Code in decimal.
1. If the NAC is correct, press the [FCN] key to advance to the next
field.
2. If a new NAC is desired, press the [CLR] key followed by the digits
of the desired NAC. Then press the [ENT] key to store this NAC and
automatically advance to the next field.
2.2.3.6 SQUELCH MODE
The next field is the Receiver Squelch Mode for Channel 1. This setting
is only used if the receive mode selected was Digital or Mixed, or if User
Channel Guard is activated. The upper part of the display will show
‘PRG RX ID’.
The lower part of the display will show ‘SQL-XXX’ where XXX is ‘NRM’
for normal squelch or ‘SEL’ for selective squelch.
Normal squelch opens on a matching NAC and any Talk Group ID or
Individual Unit ID. Selective squelch requires the correct NAC and the
correct Talk Group ID, and for Unit-to-Unit calls, requires a matching
Individual ID.
1. If the Squelch Mode is correct, press the [FCN] key to advance to
the next field.
PRG RX CG
D365-
PRG RX CG
000.0
PRG RX ID CG
NACXXXX
PRG RX ID
SQL--XXX