Operating instructions
Installation and Programming DMH Series VHF Radio
Page 2-12 BK RADIO
b. Press the [FCN] key to shift the display left by one
position, leaving position 8 blank.
c. Press the [PRI] key repeatedly to enter the next
character, or press the [FCN] key a second time to enter
a blank space.
d. To abandon changes, press the [CLR] key, restoring the
original label.
Press the [ENT] key to store changes and go back to the
starting point for Channel 0 settings.
2.2.2.11 REVIEW CHANNEL 0 VALUES
Press the [FCN] key repeatedly to display each value in Channel 0, then return to the
Channel 0 starting point.
2.2.3
CHANNEL
SETTINGS
At the starting point for Channel 0, the display shows ‘PRG CH 00.’ At
this point, a channel number can now be pressed to allow access to per-
channel variables such as frequencies and Channel Guard values for
that channel.
Press ‘1’ and the display will show ‘PRG CH 01.’ This is the starting
point for entering channel 1 values.
2.2.3.1 CHANNEL BANDWIDTH
At this point, pressing the [#] key will toggle the channel's bandwidth
setting. An 'N' will appear to the right of the channel number when the
channel is set for 12.5/15 kHz channel bandwidth using the narrow band
receiver filter. When there is no 'N' the channel is set for 25/30 kHz
channel bandwidth.
2.2.3.2 RECEIVE FREQUENCY
1. Press the [FCN] key and the upper part of the display will show
‘PRG RX.’ This is the receive frequency for channel 1 (in MHz).
2. If the displayed frequency is correct, press the [FCN] key to
advance to the next field.
3. If a new frequency is desired, press the [CLR] key followed by the
digits of the desired frequency. Then press the [ENT] key to store
this frequency and automatically advance to the next field.
2.2.3.3 RECEIVE MODE
After the receive frequency is set, the upper part of the display will show
‘PRG RX,’ and the lower part of the display will show ‘Mode-X’, where X
can be ‘A’ for Analog Mode, ‘D’ for Digital Mode, or ‘M’ for Mixed Mode.
1. If the mode is correct, press the [FCN] key to advance to the next
field.
2. If a new mode is desired, press the [PRI] key to cycle through the
mode settings. Press [ENT] to store the new mode and
automatically advance to the next field.
PRG
CH 0
1
PRG RX
MOD
E
--X
PRG
CH 01N
PRG RX
161.50000