Operating instructions

Installation and Programming DMH Series VHF Radio
Page 2-10 BK RADIO
Busy Channel Override - This function is similar to Busy
Channel Lockout except the transmitter PTT can be
activated by pressing the [CG] button.
To set Busy Channel operation, use the following chart:
Busy Channel Function 2 Function 3
Indication
Disable (Steady) Enable (Flashing)
Lockout
Enable (Flashing) Enable (Flashing)
Override
Enable (Flashing) Disable (Steady)
2.2.2.8.4 &
2.2.2.8.5 ANI/DTMF MODE
When function 4 is enabled (flashing) the ANI ID number will
be transmitted (as a DTMF tone sequence) with each press
of the PTT switch. See "Automatic Numeric Identification
(ANI)" in section 2.2.2.2 of this manual for instructions on
setting the ANI number.
When function 5 is enabled (flashing) the keypad becomes
active for manual DTMF operation.
When functions 4 and 5 are both enabled (flashing) the ANI
tone sequence will be transmitted only after the [ENT] key is
pressed while the transmit PTT switch is activated. A
sidetone of the ANI number transmitted will also be heard
through the speaker.
2.2.2.8.6 STORE GROUP TWO SETTINGS
Once each function 1-5 is set as desired, you can store the
changes, discard the changes, or disable all 5 functions.
Press the [CLR] key to disable all Group Two functions
(steady).
Press the [ENT] key to store new Group Two settings into
memory and advance to the next field.
Press the [FCN] key to advance to the next field without
saving changes.
2.2.2.9 CHANNEL 0 GROUP THREE FUNCTIONS
After Group Two functions are set, the display will show ‘PRG 3-12345’
for Group Three functions. As with Group One and Group Two functions,
the enabled function numbers will flash. The disabled functions remain
steady.
2.2.2.9.1 Function 1 is reserved for future enhancements.
2.2.2.9.2 Function 2 is reserved for future enhancements.
2.2.2.9.3 Function 3 is reserved for future enhancements.
2.2.2.9.4 Function 4 is reserved for future enhancements.
PRG
2--12345
PRG
2--12345
PRG
2--12345
PRG
2--12345
PRG
3--12345