Operating instructions

DMH Series VHF Radio Installation and Programming
BK RADIO Page 2-7
2.2.2.4 SCAN DELAY TIME
After the Time-Out Timer is set, the upper display will indicate ‘PRG
SCN.’ This is the Scan Delay time in seconds.
Press the [FCN] key to advance to the next field if no change is needed.
1. Press the [PRI] key to increase the scan delay time by .5 seconds,
up to 7.5 seconds. Press the [PRI] key again to change the time
from 7.5 seconds to 0.
2. Press the [CLR] key to reset the scan delay time to 0.
3. Press the [ENT] key to store the changed setting and advance to the
next field.
2.2.2.5 PRIORITY 1 CHANNEL
After the Scan Delay is set, the display will indicate ‘PRG PR1.’ The
Priority 1 Channel can be programmed as a fixed channel, tied to the
Channel Selector knob, or programmed OFF. If the radio is programmed
to transmit on the Priority 1 Channel, transmissions will occur on PR1, if
PR1 isn’t programmed OFF, when operating in Single or Dual Priority
Scan Mode.
If PR1 is a fixed channel, and the [PRI] key on the keypad is not locked
out, during normal radio operation the user can move the channel
selector to a new channel and press the [PRI] key to choose a new PR1
channel.
1. Press the [PRI] key to cycle through the priority channel options, or
enter a fixed priority channel using the number keys.
Setting the channel to ON ties the PR1 channel to the Channel
Selector knob. Pressing [CLR] or the [0] key turns the PR1 channel
OFF.
2. Press the [ENT] key to store the new priority channel and advance to
the next field.
2.2.2.6 PRIORITY 2 CHANNEL
After the Priority 1 Channel is set, the display will indicate ‘PRG PR2.’
The Priority 2 Channel can be programmed as a fixed channel, tied to
the Channel Selector knob, or programmed OFF.
The PR2 channel cannot be altered during normal radio operation.
1. Press the [PRI] key to cycle through the priority channel options, or
enter a fixed priority channel using the number keys.
Setting the channel to ON ties the PR2 channel to the Channel
Selector knob. Pressing [CLR] or the [0] key turns the PR2 channel
OFF.
2. Press the [ENT] key to store the new priority channel and advance to
the next field.
PRG SCN
2.0 sec
PRG
PR1 ON
PRG
PR2 OFF