Operating instructions

Installation and Programming DMH Series VHF Radio
Page 2-6 BK RADIO
2.2.2.1 GROUP PASSWORD
1. After entering Programming Mode the display will show ‘PRG CH
00.’
2. Press the [FCN] key.
3. The display will indicate the password for the selected group.
4a. If no change is needed for the group password, press the [FCN] key
to advance to the next field.
4b. To enter a new password, press the [CLR] key, then enter a new six-
digit password. Press the [ENT] key to store the new password and
advance to the next field.
2.2.2.2 AUTOMATIC NUMERIC IDENTIFICATION (ANI)
1. After the group password is set, the display will indicate the ANI ID
number (as many as seven digits may be used). The ID number can
be used for either radio management or transmitted as a DTMF tone
burst for ANI purposes. The ANI can be enabled or disabled. See
“ANI/DTMF Mode” in section 2.2.2.8.4 & 2.2.2.8.5 of this manual.
2a. If no change is needed for the ID number, press the [FCN] key to
advance to the next field.
2b. To enter a new number, press the [CLR] key and then the number
keys. The digits will appear at the right of display and move to the
left. Press the [ENT] key to store the new ID number and advance
to the next field.
2.2.2.3 TRANSMITTER TIME-OUT TIMER
After the ID number is set, the display annunciators will indicate ‘PRG
TX.’ This is the duration of the transmitter Time-Out Timer. 0 SEC means
the Time-Out Timer is disabled.
Press the [FCN] key to advance to the next field if no change is needed.
1. Press the [PRI] key to increase the Time-Out Timer duration by 15
seconds, with a maximum of 225 seconds (3 minutes, 45 seconds).
Press the [PRI] key again to change the duration from 225 seconds
to zero.
2. Press the [CLR] key to set the Time-Out Timer duration to zero.
3. Press the [ENT] key to store the changed setting and advance to the
next field.
PRG
P123456
PRG
CH 00
PRG ID
0000000
PRG TX
225 sec