Operating instructions

Installation and Programming DMH Series VHF Radio
Page 2-2 BK RADIO
8. Mount the microphone hanger clip securely to the desired location. The microphone
hanger clip must be grounded for proper radio operation. Use the supplied ground wire if
needed.
9. Mount any approved accessory speakers and route the wires to the rear of the radio
bracket.
10. Connect the power lead, antenna connector, and accessory wires to the rear of the radio.
11. Place the radio in the mounting bracket, adjust to the proper mounting angle, and thread
in the two side mounting knobs until the unit is secure.
NOTE: Option A and B connections are logic level outputs. Consult your BK Radio dealer
before connecting accessories to these pins.