Owner`s manual

22 BK Radio
CHANGE THE SCAN LIST
The radio can be programmed to enable the user to
add or remove channels from the scan list. If user
changes are enabled, follow these steps to change the
scan list:
1. Turn Scan and Priority Scan off.
2. Select a channel to be added or removed from the
scan list by turning the Channel Selector knob. If
the channel is already on the scan list, SCN
appears in the display.
3. Press and hold the [SCN] button for more than 1
second to toggle the channel on or off the scan list.
GROUP SCAN
Channels on each "Channel Scan List" in groups on
the "Group Scan List" are scanned sequentially. The
selected group is always scanned when Group Scan is
enabled, even if that group is not on the Group Scan
List.
When Group Scan is enabled, the following features
are disabled:
• Priority Scan
• Dual Priority Scan
• User-Selected Channel Guard
• Nuisance Channel Delete
PRIORITY SCAN
Priority Scan enables the radio to receive on any
channel while monitoring for a message on the
designated priority channel(s). The radio samples each
priority channel at a preset rate (.25-2.0 seconds)
regardless of activity on any other channel. Priority
Scan operates only while the radio is not transmitting
and can be used in combination with scan operation.
DMH Owner’s Manual 19
HOM Home Channel
Press the [HOM] button to go to the pre-
programmed Home Channel.
To set a different Home Channel, select the
desired channel using the Channel Selector
knob, press the [HOM] button, and hold it for
more than 1 second until the arrow above the
HOM button appears on the display. The new
channel then becomes the Home Channel.
SPK Remote Speaker
Press the [SPK] button to toggle between the
built-in radio speaker and a remotely mounted
speaker.
NXT Next Scan Channel
Press the [NXT] button to select the next
consecutive channel in the Scan List (not
during scan operation).
LPW Low Power Select
Press the [LPW] button to toggle between
high power and low power transmitter
operation. Transmitter power settings can be
programmed from 15 to 50 watts. If per-
channel power is enabled, channels locked to
low power will always transmit in low power
mode regardless of the state of the LPW
button.
GSC Group Scan
Press the [GSC] button to enable or disable
Group Scan operation. During Group Scan
operation, the following features are disabled:
Priority Scan, User Channel Guard, and
Nuisance Channel Delete.
Turn Group Scan off, then press the [GSC]
button for 1 second or more to toggle the
current group on or off the Group Scan List.