Instruction manual

Volts. The input VOLTAGE data is in Numeric Data for-

mat. The <Channel_list> above, indicates for which all

CHANNELS the DATA has to be SET. The same data will

be set on all the specified CHANNEL(S). If no such

<Channel_list> is provided the SOURce command will

always SET to channel 1.

For example to set 10.5 Volts on Channel 2, send the

command as:

SOURce:VOLTage 10.50(@2)

For example to set 30 Volts on Channels 1&2,send the

command as: VOLTage 3.00 E+1(@1:2)

3. Command : [SOURce:]CURRent<SP><NR.DATA>

<Channel_list>

Description : Set the Output Current Limit for that Channel(s).

Function : This command sets the Output Current of the Power

Supply output with the <NR.DATA> given in the command

in AMPS. The input CURRENT data is in Numeric Data

format. The <Channel_list> above, indicates for which

all CHANNELS the DATA has to be SET. The same data

will be set on all the specified CHANNEL(S). If no such

<Channel_list> is provided the SOURce command will

always SET to channel 1.

For example to set 2.3 Amps on Channels 1&2 send the

command as:

SOURce: CURRent 2.300 E+0(@1,2)

For example to set 1 Amp on Channel 1 only, send the

command as:

CURR 1

For example to set 1.99 Amps on Channel 2, send the

command as:

SOUR:CURR 199 E-2(@2)

4. Command : [SOURce:]VOLTage:LIMit<SP>

<NR.DATA><Channel_list>

Description : Set the Upper Limit of O/P Voltage for that Channel(s).

Function : This command sets the Soft Upper Limit for Output

Voltage of the specified CHANNEL(S) of the Power

Supply output with the <NR.DATA> given in Volts. The

input VOLTAGE data is in Numeric Data format. The

<Channel_list> above,