User manual

Sine Menu

F1: Frequency – Selects and displays the frequency. Change the frequency setting using the

cursor keys, rotary knob, or numerical keys.

F2: Amplitude – Selects and displays the amplitude. Change the amplitude setting using the

cursor keys, rotary knob, or numerical keys.

F3: Offset – Selects and displays the offset parameter. Change the offset by using the cursor

keys, rotary knob, or numerical keys. If a certain setting cannot be produced, the waveform

generator will display a “Setting Conflict” message.

Amplitude and offset settings interact and are bound by hardware restrictions. To obtain the

desired waveform, the amplitude and offset must satisfy the following formula:

(Vp-p)/2 + |offset| <= 5 volts

F4: Symmetry – When the Square or Triangle waveforms are selected, the SYMMETRY

(duty cycle) parameter is available. Change the symmetry (Triangle) or duty cycle (Square) by

using the cursor keys, rotary knob, or numerical keys. If a certain setting cannot be produced,

the waveform generator will display a warning message.