User manual

37
An attempt was made to RECALL the contents of an uninitialized stored
setting buffer.
-211 Trigger ignored.
The *TRG common command was ignored due to the device not being in
the correct state to execute the trigger.
-220 Parameter error.
A parameter is in the correct range, but conflicts with other parameters.
-221 Settings conflict.
The parameter is out of range due to the current instrument state.
-222 Data out of range.
-223 Too much data.
The arbitrary waveform memory limit has been exceeded.
-224 Illegal parameter value.
The parameter value must be selected from a finite list of possibilities.
Device-Specific Errors
An error specific to the device occurred.
-315 Configuration memory lost.
Device memory has been lost.
-330 Self-test failed.
-350 Queue overflow.
Error codes have been lost due to more than 10 errors being reported without being read.
Query Errors
A query error indicates that the output queue control has detected a problem. This could
occur if either an attempt was made to read data from the instrument if none was available, or
when data were lost. Data could be lost when a query causes data to be formatted for the
controller to be read, and the controller sends more commands without reading the data.
-410 Query INTERRUPTED.
Data were sent before the entire response of a previous query was read.
-420 Query UNTERMINATED.
An attempt was made to read a response before the complete program message meant to
generate that response was sent.
Warnings
The execution of some commands might cause an undesirable instrument state. The
commands are executed, but a warning is issued.
500 Trigger rate short