User manual

23
Function
Sine
Output Waveform
Frequency
1.0000 kHz
Waveform Frequency
Amplitude
5.00 V
Peak-to-peak output amplitude
Offset
0.00 V
Zero DC offset
Output
OFF
Output disabled
Sweep
OFF
Sweep function disabled
Modulation
OFF
Modulation function disabled
N-BURST
2
Wave per burst for burst mode
Trig Source
Continuous
Continuous trigger
Trig Rate
10 ms
Internal trigger rate
3.11 Memory
The waveform generator uses non-volatile flash memory for storing the front panel settings.
4014B: Up to 10 front panel settings can be stored (includes storage location 0 for factory
default settings).
4040B: Up to 20 front panel settings can be stored (includes storage location 0 for factory
default settings).
3.12 Displaying Errors
The waveform generator displays error messages when front-panel settings are either invalid
or may produce unexpected results.
Table 2 – Error Messages
Message Text
Description
Out of range
The set value is out of the instrument’s limits.
Setting conflict
Settings conflict with another parameter setting or value.
Empty location
Attempt to recall settings from an empty storage location.
Trig rate short
Internal trigger rate is too short to output waveform or burst.
Save RAM
New firmware installed.
3.13 Quick Start
This section explains how to generate various waveforms and modify the output waveform.
* Generating a waveform output
* Modifying waveform output
* Storing and recalling a waveform generator setup
3.13.1 Selecting a Standard Waveform