Instruction manual

100
The communication session was interrupted before it was finished (no
terminator was sent).
Err -410: Query interrupted
A command was received before the response to the previous interrogative
command was sent.
Err -420: Query unterminated
The power supply was addressed to talk (to send data over the interface), but it
didn’t previously receive a command which sends data to the output buffer (an
interrogative command).
Err 510: Command allowed only in RS232
system:remote command was sent, when GPIB interface selected.
Self Test Errors
Self test errors are user defined. They are generated after power up.
Here are self test errors generated by the power supply:
Error 601: Front panel does not respond
Error 602: CV not high
Error 603: CV not low
Error 604: CC not high
Error 605: CC not low
Error 606: OVP not high
Error 607: OVP not low
Error 608: Fan test failed
Error 609: Unable to sense line frequency
If one of the errors above is generated, the power supply must be turned off and
then turned on. If one of these errors is generated again, the power supply must
be delivered to B&K Precision for service.