User manual

5. These numbers represent the step numbers of the sequence, where “0” represents step

number 10. At this point, use the numeric keypad and try to push any numbers 0 – 9.

Notice that the number you press will correspond to the number displayed in Active

Step and will toggle to display a “Y” in its place.

6. The “Y” represents a selection of the step number, making it an active step (meaning

the step is enabled in the sequence). For the steps you want to configure as active, use

the numeric keypad to select so that the corresponding number changes to “Y”.

Pressing the same number will change the “Y” back to the corresponding number. For

example, if you want to configure and store a sequence with steps 1, 4, 6, and 8, press 1,

4, 6, and 8 on the numeric keypad so that the following will display:

7. For this example, steps 1, 2, 3, 4, and 5 will be used, so use the numeric keypad and

press 1, 2, 3, 4, and 5 until it displays:

8. Once set, press . The display will change to the following:

SEQ

Active Step: 0987654321

SEQ

Active Step: 09Y7Y5Y32Y

SEQ

Active Step: 09876YYYYY

EDIT SEQ VOLTAGE

Seq Step 1 Voltage = 1.000V