User manual

5. The selected item will be blinking. Use keys to move through the menu items.

When there is a on the right side of the display, that means there are more menu

items available to select from. Similarly, a will appear on the left side of the display

when there are menu items to the left. Use the keys accordingly to select the

desired menu item.

6. Press to access the selected menu item.

7. There may be parameters or options to select within each menu item. Follow the same

instructions as described in the previous steps to select them. To save changes to a

setting, press .

8. To exit the menu at any time, press twice.

3.2 Configure Voltage and Current Output

Voltage and current can be set from the front panel. Remote sense is also available on the rear

panel for voltage compensation at the output.

Setting Voltage

Follow the steps below to set the output voltage:

1. From the normal front panel display, users can use either the voltage adjust knob or the

numeric keypad to enter the setting voltage.

2. If entering using numeric keypad, press first so that the cursor selects the

voltage display. Then, enter the value and press to set the voltage.

3. To change the cursor position to adjust with the voltage adjust knob, use the keys

to move left or right.

Note: To see the changes to the setting voltage, be sure the display is not showing the

measured voltage. This can be checked by looking at the button backlight.

If it is not lit, display is showing setting voltage.

SYSTEM MENU

Initialize Power-On