User manual

20
3 Front Panel Operation
3.1 Menu Options
All settings and parameters can be configured from the built-in menu system of the power
supply. To access the menu, press and press .
The menu system is divided into 4 sections and are organized as follows:
SYSTEM
Initialize
Reset power supply settings to factory default values.
Power-On
Configure power-on state.
Trigger
Configure Trigger.
Memory
Select memory location for save/recall instrument settings.
Buzzer
Enable/Disable key sound.
Communication
Select communication interface.
ReturnMeter
Enables automatic delay to switch display from setting to
measured value (meter).
CONFIG
Load
Enables dummy load to increase speed of voltage fall time.
Ext-Ctrl
Configures external analog control.
Limit
Configures voltage setting limits.
Online
Configures series/parallel connection and master/slave mode.
LIST
Off
Recall
Recall list file.
EditList
Configure list operation.
EditSeq
Configure sequence operation.
INFO
Show model, firmware version, and serial number.
How to Access the Menu
Before using the instrument, it is important to be familiarized with its menu structure and learn
how to view or change settings and parameters. Follow the steps below to guide you in
selecting menu options.
1. From the normal display, press and press to enter the menu.
2. The selected item will be blinking. Use keys to move through the menu selections.
3. When the desired menu section is blinking, press to access its menu settings.
4. Below is the display when SYSTEM is selected.