Specifications

MLSTD-1472E
I++
Sw
--J-
+
MAXIMU
I
“’’’mum
k
OIMIENSIONS
I
OISPLACEUENT
H
i
w A
NOISIII
Width
Nolmel
n-v
Amklo
Op*roli@
TOIOI L*D
*t*
?108i0n
MO.mwt
Zsmmllw
7s m (3lnJ
13mmIln$ll.}’ ZSK9W11MIJ
mmalfl w mmm(l h.]
ssmmrwahd
6SWMU
0412Jm
lsomm (71n)
ReslsTANcc
I
I
I
FOOtNOIR,SIIW
Feat Resting Anklo
7sial LOO
●n Pod.1
OmP*d*l
FJ*aiuI 0+
Mow-l
18 N 14lb]
45 N (IO
Ibl
45 N (10 lb)
WNl?Olbl
I
90 Nt201N
I
45 N ttO lbJ
I
BOO N IIM ibl
SEPARATION
s
Om F**1 Rmdmm
O**
Faolsaqwntid
Maiawm
IOOwun (4 h.)
somm(2klJ
Pcol.,..d
!60 mm f6 III,!
10DMIMt4 k)
\
FIGURE 20. Pedals
5.4.4 ~
.
5.4.4.1 ~. In general, controls requiring operator forces exceeding the strength limits of the
lowest segment of the expected user population shall not be used. In addition, high force controls
shall not be used except when the operator’s nominal working position provides proper body support
or limb support or both,e.g., seat backrt%t,foot support. Sustained(i.e., durations longer than
1 seconds) high force rqticmcnts shall bc
woidcd.
5.4.4.2 ~, ha
ml.
and thumb-lineer contrul$. Wherearm, hand and thumb-tmger concrois
requiringhigh control forces are to be used, the maximum force requirements shall not exceed those
specified m F:gure 21, and shodd be comecwd, where applicable, for females. (’1w() thirds ol each
Jalue shown is considered to be a reasonable
adjustment.) (M? Table T.)