Owner`s manual

BJ Devices TB-12(TB-5) MIDI CONTROLLER. Owner’s manual. Version2.3

Connecting External Devices

TB-12(TB-5) midi-controller can be used together with non-midi devices as well. There are four dedicated

jacks on its back panel.

Expression Pedal 1 and Expression Pedal 2

There are two expression pedal 1/4" stereo jacks labeled Exp.P1 and Exp.P2. They allow to connect

external expression pedals or volume pedals. These pedals will allow you to control continuous effects,

such as volume, wah, whammy, etc. Use a stereo or Y-cable to connect external expression pedals.

Expression pedal settings are in Exp&Tap&Tuner menu. Enter Setup menu and navigate to EXP P1 setup or

EXP P2 setup (depending on which pedal you are configuring) and set effect CC number(see Fig. 20) and

the type of the pedal(s) used - linear or logarithmic (see Fig. 21).

Fig. 20

Fig. 21

Expression pedals calibration can be performed in the Exp P clb. menu. Prior to the beginning of the

calibration procedure at the bottom of the menu bar, you can see the current position of the pedal. If the

pedal is in the lowest position, the position value must be equal to 0 in the upper pedal position value is

127 (see Fig. 22). If the values do not reach the extreme, you need to calibrate.

Fig. 22

Press for the calibration procedure begin. In the first step move peal to lowest position and press

(see Fig. 23)

Fig. 23

Next, move pedal to high position and press (см. Fig. 24)