Product Card

devices produced by a specific manufacturer. If any hardware modify or RF control
software modify will be made by host manufacturer,C2PC or new certificate should
be apply to get approval,if those change and modification made by host
manufacturer not expressly approved by the party responsible for compliance ,then
it is illegal.
This radio transmitter 2AVP7-K3V1 has been approved by Federal Communications
Commission to operate with the antenna types listed below, with the maximum
permissible gain indicated. Antenna types not included in this list that have a gain
greater than the maximum gain indicated for any type listed are strictly prohibited
for use with this device.
Unique antenna connector (IPEX) must be used on the Part 15 authorized
transmitters used in the host product.
Antenna
Type
Antenna Model
Gain (dBi) Remark
2.4 GHz 5GHz
PIFA 1000423 0.6 dBi 4.5 dBi With 130 mm cable
PIFA 1000423 0.6 dBi 4.5 dBi With 60mm cable
If the FCC identification number is not visible when the module is installed inside
another device, then the outside of the device into which the module is installed
must also display a label referring to the enclosed module. This exterior label can use
wording such as the following: “Contains Transmitter Module FCC ID: 2AVP7-K3V1”
Or “Contains FCC ID: 2AVP7-K3V1”
Any company of the host device which install this modular with limit modular
approval should perform the test of radiated & conducted emission and spurious
emission,etc. according to FCC part 15C : 15.247 and15.209 & 15.207 ,15B Class B
and 15.407 Subpart E requirement, Only if the test result comply with FCC part 15C :
15.247 and 15.209 &15.207 ,15B Class B requirement，then the host can be sold
legally.
USA Local Representative:
Company Name Bizerba USA Inc.
Company Addr
1804 Fashion Court, Joppa, MD 21085, USA
Website http://www.bizerba.com