User's Manual
Rev. 1.00
-
9
-
SRP
-
35
0
II
OBE
1-2 Connecting the Cables
You can connect up the three cables to the printer. They all connect to the connector panel
on the back of the printer, which is shown below:
※ NOTE
Before connecting any of the cables, make sure that both the printer and the host are
turned off.
1-2-1 Ethernet Interface
1) Ethernet Interface specifications
Item Description Remark
Network Interface 10/100 Base-T All in one type (Auto detection)
Protocol TCP, UDP, IP, ICMP, ARP
IP mode Static IP, DHCP(Dynamic Host Configuration Protocol)
RX buffer 2 KByte
Flow control Hardware (RTS/CTS)
2) Ethernet Interface cable
Drawer kick-out
connector
Power supply
connector
Interface connector
(Ethernet)