User's Manual

Rev. 1.00

SRP

OBE

1-3 Connecting the Drawer

※ WARNING

Use a drawer that matches the printer specification. Using an improper drawer may

damage the drawer as well as the printer.

※ CAUTION

Do not connect a telephone line to the drawer kick-out connector; otherwise the printer and

the telephone line may be damaged.

Plug the drawer cable into the drawer kick-out connector on the back of the printer next to

the power supply connector.

Pin No. Signal name Direction

1 Frame GND -

2 Drawer Kick-Out Driver Signal #1 Output

3 Drawer Open / Close Signal Input

4 +24V -

5 Drawer Kick-Out Driver Signal #2 Output

6 Signal GND -

1-4 Setting the Dip Switches

• DIP Switch 1

SW Function ON OFF Default

1-1 Reserved - - OFF

1-2 Reserved - - OFF

1-3 Reserved - - OFF

1-4 Reserved - - OFF

1-5 Auto Cutter Auto cutter disable

Auto cutter enable

OFF

1-6 Reserved - - OFF

1-7 Near-End Sensor Status Disable Enable ON

1-8 Bluetooth mode selection

iOS mode Normal mode OFF

※ Auto Cutter Enable / Disable selection

Dip Switch Set 1

SW 1-5

ON Auto Cutter Disabled

OFF Auto Cutter Enabled

Application Ignores Auto Cutter error for continuous printing.