User`s manual

Rev. 1.03
- 18 -
SRP-330
1-6 Using the Printer
1-6-1 Control Panel
1-6-2 Mounting 2” Partition
Hang the partition at the front and press down the rear to mount the 2” partition as shown in
the picture.
※ Caution
After using 2"(58mm) paper roll, do not replace it with 3"(79.5±0.5mm) paper roll.
○ POWER
The POWER light is on whenever the printer is on.
○ ERROR
This indicates an error.
○ PAPER
This light indicates the near end of the paper roll. Install a new
paper roll and the printer will continue printing. When the light
blinks, it indicates the self-test printing standby state or macro
execution Standby state when the macro execution command is
used.
○ FEED
Press the FEED button once to advance paper one line. You can
also hold down the FEED button to feed paper continuously.