User manual

Rev. 1.05
- 40 -
SRP-150
GS ^ r t m
[Name] To run the macro
[Type] ASCII GS ^ r t m
HEX 1D 5E r t m
DECIMAL 29 94 r t m
[Range] 0 ≤ r ≤ 255 , 0 ≤ t ≤ 255 , 0 ≤ m ≤ 1
[Description] To run the macro
- r: Repetition frequency of macro execution.
- t: Delay time for executing all macros is t X 100 msec.
- m: Macro execution mode
LSB of m = 0
Macros will be executed r times continuously with a delay time of t.
LSB of m = 1
After waiting for the delay time t, paper out LED indicator blinks, and the
printer is in standby until the feed button is pressed. One the button is
depressed, the printer executes the macro once. And this operation is
repeated r times.
GS f n
[Name] To select the font of HRI (Human Readable interpretation) characters
[Type] ASCII GS f n
HEX 1D 66 n
DECIMAL 29 102 n
[Range] n = 0, 48
[Description] To select the font of HRI characters used for barcode printing
Chinese version is not supported.
Select the font as in the table shown below.
N
Font
0,48 Font A (12 * 24)
GS h n
[Name] To set the height of the barcode
[Type] ASCII GS h n
HEX 1D 68 n
DECIMAL 29 104 n
[Range] 1 ≤ n ≤ 255
[Description] To set the height of the barcode
n is number of dots in vertical direction.
[Default value] n = 162