User manual

Rev. 1.05
- 36 -
SRP-150
<Function 2> GS ( E pL pH fn d1 d2 d3 (fn=2)
[Format]
[Range]
[Description]
ASCII GS ( E pL pH fn d1 d2 d3
Hex 1D 28 45 pL pH fn d1 d2 d3
Decimal 29 40 69 pL pH fn d1 d2 d3
(pL + pH x 256) = 4 (pL=4, pH=0)
fn=2
d1=79, d2=85, d3=84
▪ Ends the user setting mode and performs a software reset. Therefore, the
printer clears the receive and print buffers, and resets all settings (user-
defined character, downloaded bit images, macros, and the print mode) to
the mode that was in effect at power on.
▪ This function code (fn=2) is enabled only in the user setting mode.
<Function 3> GS ( E pL pH fn [a1 b18...b11]...[ak bk8...bk1] (fn=3)
[Format]
[Range]
[Default]
[Description]
ASCII GS ( E pL pH fn [a1 b18...b11]... [ak bk8...bk1]
Hex 1D 28 45 pL pH fn [a1 b18...b11]... [ak bk8...bk1]
Decimal 29 40 69 pL pH fn [a1 b18...b11]... [ak bk8...bk1]
10 ≤ (pL + pH x 256) ≤ 65535
fn=3
a=2, 9,10
b=48, 49, 50
▪ all switches are set to Off (b=48).
▪ Change the memory switch specified by a to the values specified by b.
- When b=48, the applicable bit is turned to Off.
- When b=49, the applicable bit is turned to On.
- When b=50, the applicable bit is not changed.
▪ When a=2, the memory switch 2 is set as follows :
Bit Setting value Function
1 Reserved
48 Autocutter Function : Partial Cutting
2
49 Autocutter Function : Full Cutting
3~8 Codepage selection
▪ When a=9, the memory switch 9 is set as follows :
Bit Setting value Function
48 ENG
1
49 Chinese/Korean
2~4 Reserved
5~8 International Character Set selection
▪ When a=10, the memory switch 10 is set as follows
Bit Setting value Function
1 Reserved
48 Font A(12x24)
2
49 Font C(9x24)
48 Printing density : Normal
3
49 Printing density : Dark
4~5 Reserved
6~8 Partial cutting step selection