User manual

Rev. 1.05
- 28 -
SRP-150
ESC % n
[Name] To select/cancel user defined character set
[Type] ASCII ESC % n
HEX 1B 25 n
DECIMAL 27 37 n
[Range] 0 ≤ n ≤ 255
[Description] To select/cancel user-defined character set.
User-defined character set is cancelled when LBS of n is 0,
User-defined character set is selected when LBS of n is 1.
ESC & y c1 c2 [x1 d1… d(y X x1)]…[xk d1…d(y X xk)]
[Name] To define user-defined characters
[Type] ASCII ESC & y c1 c2 [x1 d1… d(y X x1)]…[xk d1…d(y X xk)]
HEX 1B 26 y c1 c2 [x1 d1… d(y X x1)]…[xk d1…d(y X xk)]
DECIMAL 27 38 y c1 c2 [x1 d1… d(y X x1)]…[xk d1…d(y X xk)]
[Range] y = 3
32 ≤ c1 ≤ c2 ≤ 126
0 ≤ x ≤ 12 (Font A (12×24))
0 ≤ d1… d(y × xk) ≤ 255
[Description] To define user defined characters.
y defines the number of bytes in the vertical direction.
c1 defines the code of beginning character, and c2 defines the end code.
x defines number of dots in horizontal direction.
ESC * m nL nH d1... dk
[Name] To set bit image mode
[Type] ASCII ESC * m nL nH d1... dk
HEX 1B 2A m nL nH d1... dk
DECIMAL 27 42 m nL nH d1... dk
[Range] m = 0, 1, 32, 33
0 ≤ nL ≤ 255 , 0 ≤ nH ≤ 3 , 0 ≤ d ≤ 255
[Description] Use m to select the bit image, where number of dots is defined by nL and
nH as shown below.
Vertical Direction Horizontal Direction (*1)
m
Mode
Number
of dots
Density Density Number of Data (k)
0 8-dot single-density 8 67 DPI 100 DPI
nL + nH × 256
1 8-dot double-density 8 67 DPI 200 DPI
nL + nH × 256
32 24-dot single-density 24 200 DPI 100 DPI (nL + nH ( 256)(3)
33 24-dot double-density 24 200 DPI 200 DPI (nL + nH ( 256)(3)