Service manual

SRP-150
Rev. 1.02
- 16 -
3-2 General Specifications
Item Description Remark
Product
• SRP-150 : Serial Communication (RS-232C)
• SRP-150P : Parallel Communication (IEEE1284)
• SRP-150U : USB2.0 Communication
Processor • V850ES/JG3-L
Memory
• M29W160EB(16Mbits)
Interface Serial
(RS-232C)
• Flow Control : DTR / DSR (H/W Flow Control)
• Baud Rate :9600~115200 bps
• Receive Buffer : 4KBytes
• Connector: DSUB-9P female connector (I/F PBA side)
The Baud Rate is
determined by DIP S/W
position.
Interface Parallel
• Mode :
1) Forward Mode : Compatibility Mode
2) Reverse Mode : Nibble Mode
• Connector: DSUB-25 type
USB
• Transfer Type : BULK
• Speed : 12 Mbps (Full-Speed)
• Power : Self-Powered
Printer
• Printing Method : Thermal Line Printing
• Printing Speed
Mono 70mm/Sec, 18.6 Line/Sec
Auto Cutter
• Type : Guillotine
• Cutting Method : 1 Point Partial Cutting
Power Consumption • Approximately 36 W (maximum)
SMPS
• Input : AC 100V ~ 240V, 50Hz/60Hz
• Output : DC 12V±5%, 3A
Environment
Condition
• Input : AC 100V ~ 240V, 50Hz ~ 60Hz
• Output : DC12V±5%,3A
Weight • 1.1 Kg (With Packing)
Dimensions(mm) • 131(W) x 194.5(D) x 124(H)
Table 3-2. General Specification
3-3 Thermal Printer Specifications
3-3-1 Printer Specification
Item Description Remark
Model • SRP-150
Print Method • Thermal Line Printing
Dot Density • 0.125mm(8 Dots/mm)
Printing Direction • Unidirection with friction feed
Printing Width • 48mm, 384 dots Position
Character / Line • 32CPL( Font A)
Character Spacing • 0.25mm (0.01) (2 dots) (Font A)
Printing Speed • Max. 70mm (18.6 Lines / Sec, 2.75inch feed)
Paper feeding Speed • Approx. 60mm /Sec
Table 3-3-1. Thermal Printer Specification