Specifications

SPP-R300 Command Manual
Rev. 1.00 BIXOLON
- 99 -
Baud rate is specified as follows: (1 ≤ k ≤ 6)
d11~dk1 Function
“115200” Baud rate 115200
“57600” Baud rate 57600
“38400” Baud rate 38400
“19200” Baud rate 19200
“9600” Baud rate 9600
“4800” Baud rate 4800
“2400” Baud rate 2400
Parity (a=2) is specified by d as follows:
d Function
48 Select no parity
49 Select odd parity
50 Select even parity
Flow control(a=3) is specified by d as follows:
d Function
48 Select flow control DTR/DSR
49 Select flow control XON/XOFF
Data Length(a=4) is specified by d14 as follows:
d Function
55 Select 7bits length
56 Select 8bits length
Remarks:
■ The change of settings of serial interface is available by adjusting the corresponding DIP switch that is recommended
for setting of serial interface.
■ To enable the settings by this command, it is first required to adjust the DIP switch that activates the serial interface
configuration set by the memory switch.
Differences:
■ Buad rate range available by the printer model:
• The serial interface configuration is specified only by setting the memory switch.