Instruction Manual

INFLATING THE PIRATE SHIP SIDES AND BACK
8. Find and open the inflating valve(s) (Fig 2).
9. Blow up sides and back by mouth or use hand held electric pump.
10. Once inflated close the valve immediately and press firmly (Fig 3).
DEFLATING THE PIRATE SHIP (BASE)
11. Open the large air outlet near the control panel (Fig 4).
12. Turn the knob on the control panel to DEFLATE.
13. Once deflated, turn the knob on the control panel to OFF, unplug the unit and store the cord
inside the control panel door (Fig 5).
SETTING UP THE PIRATE SHIP
ADULT ASSEMBLY AND SUPERVISION REQUIRED
1. Clear an indoor area (see diagram) and place the folded product inside the area.
2. Fully unfold the product with the built in motor near a 120 volt AC wall electrical outlet.
MINIMUM CLEARANCE ZONES
Make sure that there is a 2m (6.6 ft) obstacle-free zone around the product.
INFLATING THE PIRATE SHIP BASE (MATTRESS)
3. With the knob on the control panel in the OFF position, open the cord storage area door and
carefully extend the cord (Fig. 1).
4. Plug the cord into the wall outlet.
5. Turn the knob on the control panel to INFLATE (Fig. 1).
6. Allow the mattress to inflate until it is frim but the seams still show slight wrinkling then turn
the knob to OFF. (DO NOT over-inflate).
NOTE: The knob must be completely centered at OFF to prevent deflation (Fig 1A).
7. Place the power cord in the control panel cord storage door prior to allowing children to play
on the product.
REAPAIRING A PUNCTURE
In the event the product is accidentally punctured, an adult must perform the following steps:
1. Deflate the item, clean the punctured area with water and allow to dry.
2. Cut to required size depending upon hole or puncture.
3. Remove vinyl patch from paper backing.
4. Press patch firmly over hole or puncture.
5. Do not inflate for 20 minutes.
MAINTENANCE
The product should be periodically examined for potentially unsafe conditions such as: damaged
cord, plug, housing, etc. In the event such damage is found, the product should not be used until
properly repaired. Refer to the instructions for set-up, maintenance and care. To clean use mild
detergent and water.
2m (6.6 ft)
2m (6.6 ft)
2m
(6.6 ft)
2m
(6.6 ft)
Fig. 4 Fig. 5
Open for
cord storage
Fig. 1
Fig. 1A
DEFLATING THE PIRATE SHIP SIDES AND BACK
14. Locate the valve(s) on the base, sides and back. Release large valve.
Press down on product until all the air has been expelled.
Fig. 2
Fig. 3