User Manual

Table Of Contents

Addressing a Room Remote

Introduction

Each Room Remote must be assigned a unique address. This prevents Room Remotes in different rooms (or

neighboring installations) from controlling unintended activities.

See

RF Receiver Layout for more information regarding rooms and addresses.

Enter Addressing Mode

Hold the OK and B buttons simultaneously until the red status LED comes on solid (approximately 3 seconds)

PAGE 1
Addressing a Room Remote Introduction Each Room Remote must be assigned a unique address. This prevents Room Remotes in different rooms (or neighboring installations) from controlling unintended activities. See RF Receiver Layout for more information regarding rooms and addresses.
PAGE 2
Enter The New Address Enter a new three-digit address. Valid addresses range from 001 - 255. Store The New Address Press OK to store the new address. The red status LED will flash twice if successful. The LED will flash five times if an invalid address was entered or if the procedure times out.