User Manual

Intercom Connection

Attention

Pairing is only necessary for establishing your initial connection. You can use

Just Connect Mode to establish future connections between your Universal

Remote and HBC controller.

Step 1

Pair the Universal Remote to respective HBC unit, if they have not been

paired before.

To connect the Universal Remote to the helmet communicator,

s Power ‘On’ the HBC unit and hold ‘Up’ and ‘Down’ buttons for 2

seconds until LED blinks blue and red alternately.

s While holding the ‘Up’ or ‘Down’ button, power ‘On’ the Universal

Remote, only release the ‘Up’ or ‘Down’ till the LED blinks blue and

red alternately.

s Once the connection is successful, HBC and Universal Remote will

blink blue.

s Power ‘Off’ the Universal Remote and respective HBC unit. The

Universal Remote to the respective HBC unit preparation is done.