User manual

USER MANUAL
Usage Examples of the Bitstream 3X
Usage with a synthesizer software
The Bitstream 3X is pre-programmed to be used with all the synth software responding to MIDI.
The usage of the mode « Standard » allows the direct usage of the Bitstream 3X with the software
controllable in MIDI, without any programming required.
The only choices to be made are:
− The choice of the mode « Standard »
− The MIDI channel
For these choices, see the dedicated chapters.
For the software side, the user should be sure that it is ready to accept the MIDI events, and therefore
to be controlled by the Bitstream 3X. Two examples are shown below for the two most used software
systems, Propellerheads Reason and Ableton Live. The idea is the same for any other software:
− Choice of the MIDI peripheral which is connected to the Bitstream 3X
− Choice of the MIDI channel for the reception of the Bitstream 3X generated events
− Usage of the mode « Learn » to assign a control of the Bitstream 3X to a control of the software.
If you have a configuration problem, contact the support team at Wave Idea.
Propellerheads Reason (before V3,0)
=&'(=
A'
Choice of the MIDI Input peripheral and of the reception channel (Edit->Preferences)
Rev 1.2 - Page 64