User manual

USER MANUAL
Initialisation of the Bitstream 3X
The Bitstream 3X can be initialized in user mode. It’s recommended that you do this after updating the
firmware or if there is any strange behaviour from the machine.
To initialize the Bitstream 3X, follow these steps:
1- The machine is turned off
2- Press and hold Edit – Ok – Group and turn on the machine
3- The initialization will start, the display will indicate the progression
4- Turn off and reboot the Bitstream 3X normally
$%*&'(),'1
-%*&'(+
"3
4+6
Regulating the contrast
The Bitstream 3X has a Backlight for the LCD screen for which the contrast can be adjusted
depending on the environment.
To regulate the contrast, you need a very fine/small flathead screwdriver. The adjuster is situated on
the right of the screen.
Rev 1.2 - Page 61