User manual

USER MANUAL
Using the « Assign » menus
The assign menus of the Bitstream 3X are used to re-program the controller without using the
configuration software.
%5
)
+,)))
%
The OK button will validate the access, and CANCEL takes you back to the normal screen
Once the user presses OK, the following screen will appear:
The Bitstream 3X is now waiting for the user to change the position of the control being assigned, and
enters automatically into the assign menu of the control being configured.
The navigation of this assign menu is similar to the navigation of the other menus of the Bitstream 3X.
They are organized into a hierarchy, and navigation is done with the UP, DOWN, OK and CANCEL
keys. See the menu-dedicated chapter for more information.
For each control, three menus are available:
- Assign common Parameters common to both standard and User modes
- Assign Standard Parameters reserved for standard mode
- Assign User Parameters reserved for user mode
Rev 1.2 - Page 27