User manual
USER MANUAL
The Bitstream 3X, has 2 MIDI output ports that can be selected independently by each control, it
therefore has 32 virtual MIDI channels (16 in each port).
The selection of the output port for each control is done via the « assign » menus of the Bitstream 3X,
as well as by the configuration software.
The MIDI channel of 1 to 16 can be selected directly from the user interfaces of the Bitstream 3X.
$%+5+&
'(":++
-%+$$B+
1$C1D5+
D 5 $1 5 + - )
,%&$1#<<)&$E+-1#E$1<<E
Menus associated to the MIDI channel
Selection of the scene memories
The Bitstream 3X has 100 available scene memories, also called « snapshots ».
When activated, the selection of the number of the scene memory is done by using the up-down
buttons, as well as the encoder.
To save a snapshot, it is necessary to select a number via the up-down buttons or the encoder before
saving or sending the scene. After the scene is saved or sent (via the save/send button), the Bitstream
3X will show the number chosen.
For more information on this subject, refer to the dedicated chapter.
Menus associated to scene memories
Analog behaviour
Besides the joystick, which doesn’t need the analog function, all the analog function of the Bitstream
3X can be configured in 2 modes: Hook mode or Jump mode.
Jump mode allows the instantaneous sending of MIDI data no matter what position the control is in at
the time of the change.
This mode could provoke undesirable jumps in the values when the user uses the different groups of
the Bitstream 3X, the physical value of the control may not correspond to the value of the same control
in a new group.
Hook mode allows the user to avoid any undesirable jump in values: After any group change, if the
physical position of the analog control doesn’t correspond to the value of the same control in the newly
selected group, the MIDI data is not sent while the physical position and the value are different. Thus,
no jump in value is obtained.
The LCD screen of the Bitstream 3X indicates the direction to move the control to finally generate the
MIDI.
Rev 1.2 - Page 20
MIDI channel 001 - 016
+
Scene select 000 - 099