Installation Instructions

shown in the radar window.
⑥ Installation Height
Radar measures the data assuming that it is at the same height as the object it detects. In
general, however, the radar is installed about 8 meters above the ground, resulting in
errors. Errors due to the installed position of these radars can be corrected using the
Installation Height item.
⑦ Auto Calibration
After radar is installed, it can be tilted for several reasons. In the event of such an error, it is
possible to correct the tilt with the Auto Calibration item.
⑧ Tracking Zone View
Tracking Zone View is used with items on the hotspot zone at the bottom. The hotspot zone
items have items that modify the length of the hotspot zone and items called HZ
Width/Center for visual implementation. In addition, the area where the vehicle is to be
tracked can be set through the tracking zone, which is not visible from the radar window
even if the radar detects the vehicle when the vehicle passes the tracking zone. If you check
the Tracking Zone View after you have set up all of the tracking zones, the settings for the
tracking zone are also reflected. In other words, if the Tracking Zone View is not checked
even when the tracking zone is set, its contents are not reflected. At the bottom is an item
called Horizontal Line, which functions as drawing a horizontal line to make the distance
clearer.
<Setup Track>
① Width와 Length
Width and Length can adjust the size of the rectangle that implements the tracked vehicle.
② Show Track
You must check Show Track to create a rectangle that implements the tracked vehicle.
③ View Speed
With View Speed, the vehicle's speed is derived from a rectangle. And the decimal places of
speed can also be set.
④ View ID
You can use the View ID to identify the vehicle. This makes it easier to identify the
information of the vehicle to be identified.
If all settings are finished using the Properties pane, you should reflect these settings using
the Accept button just below the Properties pane. And if you want to go back to the settings
that are basically implemented, you can use the Default button.