User's Manual

Figure 2-16-3 Figure 2-16-4
2.5.7: Scanning Barcode:
To use the scanning function, complete the following steps:
1. If you have not already done so, remove the protective plastic film before using
devices equipped with a laser scanner.
2. Select Start > Setting > Control Panel > Barcode setting, set/ enable / disable
the value of each item.
3. Run the WordPad software program
4. Aim the scanning beam at the center of bar code.
 Position the device close to bar code when scanning
 Position at a distance when scanning lager bar codes.
 The scanner is disabled after you release the key or after five seconds.
5. Press the Right/left/central scan key. The scanner scans as long as you hold the
key or for five seconds.
6. Upon reading a bar code, the red LED indicator comes on until the trigger is
release or five seconds. The green LED and the beep tone indicate a good read.
P2-25