User's Manual

2.4.2 Power (and Backlight) on / off

 To turn on the PDA

Press the Power/Backlight key briefly ( ). If the PDA does not power on, perform

the cold reset. See chapter 2.7.1.

As the PDA initializes its File system, the IT7000 splash screen displays for about 30

seconds followed by calibration screen. Every time you perform a cold reset, these

screens will also appear.

To turn off the PDA, just press the Power/Backlight key again. This action does not

actually turn off the PDA, it only turn the PDA into suspend mode. All running

applications remain as you left them, until you press the Power key again to resume

operation of the PDA

 To Turn on/off the backlight

Press the Power / Backlight key briefly to turn on the PDA. And press the key again

briefly to turn off the PDA. The backlight is always on as the default. When the PDA

is ON, press the key longer, it will turn off the backlight. Press the Power / Backlight

key a little while again, it will turn on the backlight. Or just touch the screen or press

any key, it also can turn on the backlight again.

2.4.3: Calibration of the touch Screen Figure 2-11 Calibration

When you feel the touch screen function is poor or the operation does not match the

exact location it should be, please recalibrate the screen by using the stylus to enter

into the star bar --- Setting --- Stylus, to open the “Calibration” to recalibrate again.

P2-10

On the initial boot-up of the PDA, the

stylus calibration screen (Labele

Align Screen) opens. Use the stylus

to press and hold briefly on the cente

of each target as it moves around the

screen.

If necessary, adjust the backlight on

the PDA to make the screen readable.

(See below 2.4.4. Adjusting the

brightness).