User's Manual

◆ When charging the battery pack, the Power LED on the PDA turns on Red. After
the battery pack is fully charged, the PDA Power LED turns to green.
b) Place the spare battery pack into the Single Cradle’s spare Battery charging slot
1. Connect the Power cord to the Power adapter
2. Connect the power cord to a power source
3. Plug in the connector of the power adapter with Single Cradle
4. Insert the Battery pack into the Single Cradle’s spare Battery slot
◆ When charging the Battery pack in the Single Cradle’s spare Battery slot, the
Single Cradle charging LED will turn on Red. After the Battery pack is fully
charged, this LED will turn to green
CAUTION: Please don’t remove the Battery pack too long from PDA after you
have already full-charged the Battery pack and backup battery pack and start
to use the PDA. Otherwise the data stored inside SDRAM memory will be lost.
Please also keep in mind power the PDA off if you want to change the main
Battery pack.
2.4 Handling the PDA
2.4.1 Starting the PDA
Press the Power key to turn on/off the PDA. If the PDA does not power on, perform a
cold boot. See 2-7 Resetting on page 2-XX.
CAUTION: When a battery is fully inserted in PDA for the first time, upon the
PDA’s first power up, the device boots and powers on automatically.
Figure 2-10
P2-9
When the PDA is powered on for the first time,
it initializes its system. A splash screen (figure
2-10) appears for a short period of time
followed by the Wince.NET 4.2 window.
This section offers the basic procedures of
PDA using.