User Manual

User Guide Introduction
◆ Be sure that only authorized supplier are allowed to disassemble and reassemble the
device. If the device or parts has been damaged due to any wrong handling, shall void
the product and parts warranty.
◆ Always make back-up copies of all important data. Easy done by using a cable to
transfer data to the computer. Manufacturer is not liable for any data damages or data
loss caused by deletion or corruption by using of this device, or due to the drained
battery.
◆ Lithium-ion battery packs might get hot, explode, ignite and/or cause serious injury if
exploded by abusive using. Please follow the safety warnings listed as below:
˙ Do not place the battery pack in fire or heat the battery.
˙ Do not install the battery pack backwards so the polarity is reserved.
˙ Do not connect the positive Battery pack with negative battery pack to each other with
any metal object (like wire).
˙ Do not carry or store battery pack together with metal objects.
˙ Do not pierce the battery pack with nails, strike the battery pack with a hammer,
step on the battery pack or otherwise put it to strong impacts or shocks.
˙ Do not solder directly onto the battery pack.
˙ Do not expose battery pack to liquid, or allow the battery contacts to get wet.
˙ Do not disassemble or modify the battery pack. The battery pack contains safety
and protection devices, which, if damaged, may cause the battery pack to
generate heat, explode or ignite.
˙ Do not discharge the battery pack using any device except for the specified device.
When it is used in devices other than the specified devices, the battery pack can be
damaged or its life expectancy reduced. If the device causes any abnormal current to
flow, it may cause the battery pack to become hot, explode or ignite and cause
serious injury.
˙ In the event the battery pack leaks and the fluid gets into one’s eye, do not rub the
eye. Rinse well with water and immediately seek medical care. If left untreated, the
battery fluid could cause damage to the eye.
1.3 Insert IT7000 into Holster
Please insert bottom of IT7000 into holster at first, and keep LCM face to outside in this
uni-direction way same as the below figure.
P1-2
To comply with FCC RF exposure rule, please use only the supplied holster (the supplied holster 
does not have any metallic components in the structure and will limit this product only in an 
orientation that back-face will toward user’s body), Third-party belt-clips, holsters, and similar 
accessories may not comply with this requirement and should be avoided.