474 HYDROCLEAN™ PROHEAT® COMPLETE
A-1 A-3 9 1 10 2 4 6 33 5 3 11 7 12 8 34 13 14 15 17 16 A-2 18 26 19 22 20 21 28 23 24 31 25 A-4 35 36 27 29 30 32 37 38 39 40 42 41 45 2 www.BISSELL.
B C 1 2 4 C-1 5 2 1 4 C-2 7 3 5 4 3 6 6 5 8 7 9 www.BISSELL.
1 C-3 C-4 5 5 8 1a h bv g kvh gh j d bj gh fd hn l kll sd jkn f h Ad j jh bb cv ghhjj gc C-5 1 2 7 6 D-1 D-2 9a 1 www.BISSELL.
EN 3-11 Thanks for buying a BISSELL multi-function water filtration vacuum 19-25 READ USER GUIDE FOR COMPLETE SAFETY AND USER INSTRUCTIONS. WEEE DO NOT THROW THE APPLIANCE AWAY WITH THE NORMAL HOUSEHOLD WASTE AT THE END OF ITS LIFE, INSTEAD HAND IT IN AT AN OFFICIAL COLLECTION POINT FOR RECYCLING. BY DOING THIS YOU WILL HELP TO PRESERVE THE ENVIRONMENT. 62-68 www.BISSELL.com SV GUIDE SK NOTE OR HINT WHICH IS NOT ESSENTIAL BUT MAY IMPROVE USABILITY.
EN IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING YOUR DEEP CLEANER. When using an electrical appliance, basic precautions should be observed, including the following. WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY: » Unplug from electrical socket when not in use and before cleaning, maintaining or servicing the appliance.
D o not plug in your cleaner until you have completely assembled it per the following instructions and are familiar with all instructions and operating procedures.
EN C Operations Water filter vacuuming IMPORTANT: Your cleaner is a water filtration cleaner. NEVER use it in Filter Vac mode without clean tap water in the collection tank. You MUST fill the collection tank with clean tap water to the clean water fill line on the back of the collection tank for the cleaner to function properly. Vacuuming in Filter Vac mode without clean water in the collection tank may cause damage to the motor. C-1 Getting ready 1.
C-5 Hard Floor Cleaning a. Check manufacturer’s tag before cleaning. “W” or “WS” on the tag means you can use your cleaner. If the tag is coded with an “X” or an “S” (with a diagonal stripe through it), or says “Dry Clean Only”, do not proceed with wet cleaning. Do not use on velvet or silk. If manufacturer’s tag is missing or not coded, check with the furniture maker or the furniture dealer. 2. Remove tool caddy from back of cleaner if in place. 1.
EN D Care, Maintenance & Storage D-1 Machine care 1. Push power and wet clean buttons off. Unplug cleaner. 2. Open Quick Release™ hose door and remove collection tank by lifting straight up using tank handle. 3. Remove top lid from collection tank, rinse and air dry. 4. Empty dirty water into a sink, toilet or outside by pouring dirt water out from corner of tank. Rinse inside of collection tank. 5. Remove cleaning mode selector by turning to “REMOVE” and pulling straight out. 6.
This Guarantee only applies outside of the USA and Canada. It is provided by BISSELL International Trading Company BV (“BISSELL”). This Guarantee is provided by BISSELL. It gives you specific rights. It is offered as an additional benefit to your rights under law. You also have other rights under law which may vary from country to country. You can find out about your legal rights and remedies by contacting your local consumer advice service.
