.A T. 18 7 6 U.S . ES S RT HO M NING E LEA XP E EC CLEANVIEW® CONNECT ROBOTIC VACUUM MODEL 2908N Product View. . . . . . . . . . . . . . . . . . . . 2 Setup . . . . . . . . . . . . . . . . . . . . . . . . .3-4 Operations . . . . . . . . . . . . . . . . . . . .4-5 Maintenance & Care . . . . . . . . . . . 5-8 Troubleshooting . . . . . . . . . . . . . . . . .
What’s in the Box? BISSELL® CleanView® Connect Docking Station Power Adapter (charger) Additional Pleated and Foam Filters Cleaning Tool Additional Edge Cleaning Brushes Product View WARNING Do not plug in your robot until you are familiar with all instructions and operating procedures. 1. Power Switch 2. Start/Pause Button 3. Contact Points (for automatic charging) 4. Cliff Sensors 5. Bumper 6. Edge Cleaning Brushes 7. Front Wheel 8. Rear Wheels 9. Dirt Bin Release Button 10.
Setting Up Your Robot 1 2 40 inches (1m) 40 80 inches (2m) (1m) 40 inches (1m) Insert the Docking Station Power Adapter plug into the port on the side of the Docking Station, then plug the other end into the wall outlet. Turn the robot’s Power Switch ON and put on the Docking Station. The first charge will take 4-5 hours. Place the back of Docking Station firmly against a wall. Ensure there is at least 1 meter to one side, 1 meter to the opposing side and no obstructions in front of the Docking Station.
Connecting to the App (cont.) 6 7 Scan Code The QR code needed for setup can be found by removing the Dirt Bin and turning the robot over. Once you locate and scan the QR code, follow the instructions in the app to pair. Manual Cleaning 1 2 Press the Start/Pause Button on the top of the robot to start cleaning. Press the Power Switch to the ON (I) position. When finished, press the Start/Pause Button again to stop the robot. 3 To return the robot to the dock, press the Start/Pause Button twice.
Activating Low Power Mode 1 2 15s Send the robot back to the dock. Press and hold the Start/Pause Button for 15 seconds until you hear 2 beeps. Release the button to activate low power mode. Cleaning the Dirt Bin 1 2 3 Press the button on top of the Dirt Bin and pull to remove. Open the filter door by pulling both sides apart. Empty debris from the Dirt Bin. Remove the filter cover, then the Foam and Pleated Filters. 4 Use the Cleaning Tool to brush the filter cover and filters.
Cleaning the Brush Roll WARNING To reduce the risk of electric shock, turn Power Switch OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks. 1 2 3 Pinch the tabs on the brush guard inward and pull to remove. Lift to remove the Brush Roll. 4 Clean the Brush Roll with the Cleaning Tool. Replace the Brush Roll and brush guard. NOTE: The Brush Roll has two different end pieces.
Cleaning the Sensors WARNING To reduce the risk of electric shock, turn Power Switch OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks. After repeated use, debris can accumulate on the sensors of the robot and the robot’s performance could be affected. To ensure the best efficiency, the sensors should be cleaned off periodically by brushing any debris from them.
Storing Your Robot Store your robotic vacuum cleaner safely indoors where it is unlikely to be damaged.
