User`s guide

www.bissell.com
Operations
12
1. Turn power switch off. Remove the 2-in-1
water tank from the base using the tank
carry handle. Carry the tank like a bucket to
a utility sink or outside where you will
dispose of the collection water. Remove the
top of the tank by rotating the handle for-
ward to unlatch lid and lifting lid off tank.
2. Empty collection water from bottom of tank.
3. After each use, remove and rinse the lint
screen located on the tank lid.
4. If nozzle needs to be cleaned, remove by
grasping handle at the top and pulling
forward. Clean removable nozzle by
rinsing under running water.
5. When finished, replace nozzle by slightly
raising front of machine to line up slots on
the base with the hooks on nozzle. Attach at
base first and then click nozzle into place.
NOTE:Ifnozzleisnotattached
properly loss of suction will occur.
6. To continue carpet cleaning, refer back to
pages 10 through 11, beginning with “Fill
the 2-in-1 water tank” on page 10.
Ifcleaningiscomplete,refertothe
“Maintenance and care” section on page 15.
ReadyTools™
Your CleanView
®
ProHeat
®
comes equipped
withahoseandatleastoneattachmentfor
cleaningstairs,upholstery,andmore.
Important!Ifusingthemachinetoclean
upholstery,checkupholsterytags.
1. Check manufacturer’s tag before cleaning.
“W” or “WS” on the tag means you can use
your deep cleaner. If the tag is coded with “X”
or “S” (with a diagonal strike through), or says
“Dry Clean Only,” do not proceed. Do not use
on velvet or silk. If manufacturer’s tag is missing
or not coded, check with your furniture dealer.
2. Check for colourfastness in an inconspicu-
ous place.
3. If possible, check upholstery stuffing. Coloured
stuffing may bleed through fabric when wet.
4. Plan activities to give upholstery time to
dry.
1.
3.
5.
2.
4.
Adsdfdd ghg bvh
cvbbj jkn hnbj jkvh
gcghhjj jhffhl kllgh
Manufacturer’s tag
Emptythe2-in-1watertank/cleanremovablenozzle
Lint Screen