Manual

Power switch
The Power switch on model 9595, 1816, 3918,
4207, 24101, 7482 series is located on the left
side of the vacuum. Push the rocker switch
"ON" (I) to vacuum, and "OFF" (0) when clean-
ing is complete. The Power switch on model
2412 is located on the front of the handle. Push
the button (_ once to vacuum, and push the
button (_) again when cleaning
is complete.
NOTE: You can find your model number on the
back, bottom side of the vacuum on the white
sticker by the UL rating.
Handle position
Press the handle release pedal with your foot
to place your CleanView vacuum into one of
three cleaning positions.
1. Upright - For storage and above floor
cleaning with tools.
2. Normal cleaning - Press handle release
for household floor cleaning tasks.
3. Low cleaning - With the vacuum in
normal cleaning position, press handle release
pedal again, use for reaching under low furniture
such as tables, chairs or beds.
Height adjustment
There are five height settings available for
various floor surfaces. Turn the dial on the foot
of the cleaner to the desired setting.
Lowest setting - For low pile carpet or bare
floors. To pick up debris, it may be necessary
to move up one setting.
Medium setting - For medium pile carpet.
Highest setting - For high pile and most
shag carpet.
NOTE: For optimal carpet cleaning performance,
adjust to the lowest practical setting. If your
cleaner is difficult to push, adjust to the next
higher setting.
If the dial is difficult to turn, tilt the cleaner
back slightly to take the weight off the foot
while turning.
ACAUTION
Beforeusingv0urvacuum,makesurethatthedi_
tankisinthe10(kedpositionandthatbothfilters
(prem0t0randp0st-m0t0r)areinplace.Donot
operatev0urvacuumwithoutthesefilters.
*Productimagesmayvary
www.BISSELL.com 800,237.7691
7