Manual

you'llneed__assembleyour
eanerisaPhillips-headscrewdriver.
handle to vacuum
vacuum handle and remove the
taped to the handle. The screw
:ontains two screws of equal length.
the vacuum upright and slide the
handle firmly into the opening at
of the vacuum body.
_ck to be sure the handle is fitted to the
Jm body. If there are any gaps between
_andle and the vacuum base, continue to
the handle firmly into the base until the
idle is flush.
Insert the two screws from the screw packet
the existing holes. Push each screw firmly
_to the hole before beginning to secure the
_crew with a Phillips head screwdriver. If the
handle is aligned properly on the vacuum base,
you should be able to push the screw almost
entirely into the hole until only the screw head
is visible. Tighten the screw with a Phillips head
screwdriver by rotating the screw clockwise.
2,
4,
/kWARNING
Donot0peBtevacuumwithdamp0rwetfilters
orwithoutallfilteBinplacefiBt.
Attach vacuum hose_ clips & tools
1. Attach the extension wand clip by inserting
the clip into the back of the vacuum base 1,
and twisting clockwise. Mount the extension
wand (with crevice tool inside) on the back
of the vacuum.
2. Snap the upper cord wrap into the socket
located above the extension wand clip. Wrap
the power cord around the cord wrap clips.
3. Attach the Twist 'n Snap T" hose by lining
up the tabs on the cuff with the corresponding
notches on the back of the vacuum. Twist the
Twist 'n Snap hose clockwise to lock the hose
2,
into place.
4. Slide the end of the hose wand into the
hose wand base, and fold the hose over the
upper hose wrap.
2,
3,
3.
1,
4,