Manual

Problem
Vacuum
cleaner won't
rum on
Vacuum
cleaner won't
pick up dirt
Possible causes
Power cord not plugged in
Blown fuse/tripped breaker
Incorrect height adjustment
Hose not attached to suction
opening
Crack or hole in hose
Broken or worn drive belt
Rotating floor brush bristles worn
Rotating floor brush jammed
Clog in vacuum
Dirt tank full
Dirt tank or upper tank not
installed properly
Filters are dirty
Tool won't
pick up
I
Remedies
Check electrical plug
Check/replace fuse or reset
Adjust powerfoot to correct hei!
Grasp the hose wand and firmly
into the hose wand base
Check hose and replace if needed
Replace drive belt, see page 12
Replace brush
Remove brush and clean debris from
brush ends, see page 11
Follow instructions on page 12 for
clearing clogs
Empty dirt tank
Position correctly and lock in place
or replace pre-motor
Check and clean
and post-motor filters, see pages 9, 10
Crack or hole in hose Check hose and replace if needed
Clog in vacuum Follow instructions on page 12 for
clearing clogs
Dirt tank full Empty dirt tank
Dirt tank or upper tank not Position correctly and lock in place
installed properly
Filters are dirty Check and clean or replace pre-motor